filename: tfs 160u.doc version 2.0 02.11.2012 vectron international filter specification tfs 160u 1/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. measurement condition ambient temperature: 23 c input power level: 0 dbm source impedance (balanced): 200 load impedance (balanced): 200 terminating impedance: * input: 310 || -4.8 pf output: 358 || -5.3 pf characteristics remark: the reference level for the relative attenuation a rel of the TFS160U is the minimum of the pass band att enuation. this value is defined as the insertion loss a e . the nominal frequency f n is fixed at 160,5 mhz without any tolerance. the v alues of relative attenuation a rel are guaranteed for the whole operating temperature range. the frequency shift of the filter in the ope rating temperature range is included in the production tolerance scheme. d a t a typ. value tolerance / limit insertion loss a e 14,4 db max. 15,5 db (reference level) nominal frequency f n 160,5 mhz passband pb f n 8,5 mhz pass band ripple 0,2 db max. 2,0 db bandwidth 3 db 20 mhz min. 17 mhz relative attenuation a rel f n - 8,5 mhz ? f n + 8,5 mhz 2,6 db max. 3 db f n - 50 mhz ? f n - 35 mhz 49 db min. 40 db f n " 35 mhz ? f n " 25 mhz 42 db min. 30 db f n " 25 mhz ? f n " 15 mhz 12 db min. 10 db f n + 35 mhz ? f n + 50 mhz 46 db min. 40 db group delay ripple in f n " 4 mhz *) gdr 6 ns max. " 8 ns group delay ripple in pb *) gdr 6 ns max. " 9 ns group delay variation (unit to unit) *),**) max. " 2,5 ns return loss within pb 13 db min. 6 db input power level max. 10 dbm operating temperature range otr - 40 c ... + 85c storage temperature range - 45 c ... + 85c temperature coefficient of frequency tc f ***) -94 ppm/k *) time gating window 0 ? 0.5s **) measured at centre frequency, and averaged valu e to account for unit to unit variation and differe nt bandwidth variants ***) ? f c (hz) = tc f (ppm/k) x (t - t o ) x f cat (mhz). generated: checked / approved:
filename: tfs 160u.doc version 2.0 02.11.2012 vectron international filter specification tfs 160u 2/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. filter characteristic construction and pin connection (all dimensions in mm) 7 5 1 3 1,8 max. 2,54 0,1 1,1 1,1 1 2 0 0,64 5 - 0,10 + 0,15 1 3 5 7 date code 50 test circuit l1 l3 saw 67 32 1,4,5,8 1:4 1:4 r1 r2 l2 l4 c2 c1 s160u c01 1 ground 2 output 2 3 output 1 4 ground 5 ground 6 input 2 7 input 1 8 ground date code: year + week c 2012 d 2013 e 2014 ... 120 130 140 150 160 170 180 190 200 210 -70 -60 -50 -40 -30 -20 -10 0 frequency in mhz magnitude in db 150 155 160 165 170 -5 -4.5 -4 -3.5 -3 -2.5 -2 -1.5 -1 -0.5 0 frequency in mhz magnitude in db 150 155 160 165 170 0.18 0.19 0.2 0.21 0.22 0.23 0.24 0.25 0.26 0.27 0.28 frequency in mhz delay in s
filename: tfs 160u.doc version 2.0 02.11.2012 vectron international filter specification tfs 160u 3/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. stability characteristics, reliability after the following tests the filter shall meet the whole specification: 1. shock: 500g, 1 ms, half sine wave, 3 shocks each plane; din iec 68 t2 - 27 2. vibration: 10 hz to 500 hz, 0,35 mm or 5 g respe ctively, 1 octave per min, 10 cycles per plane, 3 p lanes; din iec 68 t2 - 6 3. change of temperature: -55 c to 125c / 30 min. each / 1 0 cycles din iec 68 part 2 ? 14 test n 4. resistance to solder heat (reflow): reflow possible: three ti mes max.; for temperature conditions refer to the attached " air reflow temperature conditions" on page 4; 5. esd mil-std-883e using coupling network of iso 1 0605 and en 6100-4-2 hbm:250v; this filter is rohs compliant (2002/95/eg, 2005/618 /eg) packing tape & reel: iec 286 ? 3, with exception of value f or n and minimum bending radius; tape type ii, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: 3000 reel of empty components at start: min. 300 mm reel of empty components at start including leader : min. 500 mm trailer: min. 300 mm g do w ct f e g d1 p2 p1 po bo ao pull off direction pin marker typ date code ko t a c n w 1 w 2 the minimum bending radius is 45 mm. tape (all dimensions in mm) w : 12,00 po : 4,00 do : 1,50 e : 1,75 f : 5,50 g(min) : 0,75 p2 : 2,00 p1 : 8,00 d1(min) : 1,50 ao : 5,30 bo : 5,30 ct : 9,2 0,1 reel (all dimensions in mm) a : 330 w1 : 12,4 +2/-0 w2(max) : 18,4 n(min) : 50 c : 13,0
filename: tfs 160u.doc version 2.0 02.11.2012 vectron international filter specification tfs 160u 4/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. air reflow temperature conditions conditions exposure average ramp-up rate (30c to 217c) less than 3c/ second > 100c between 300 and 600 seconds > 150c between 240 and 500 seconds > 217c between 30 and 150 seconds peak temperature max. 260c time within 5c of actual peak temperature between 10 and 30 seconds cool-down rate (peak to 50c) less than 6c/second time from 30c to peak temperature no greater than 300 seconds temperature / c time / s max. 260 c 217c 10 ... 30 s 30 ... 150 s max. 300 s chip-mount air reflow profile
filename: tfs 160u.doc version 2.0 02.11.2012 vectron international filter specification tfs 160u 5/5 vectron international gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vectron international gmbh reserves the right to ma ke changes to the product(s) and/or information con tained herein without notice. no liability is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or information. history version reason of changes name date 1.0 - generation of development specification chilla 14.02.2011 1.1 - changed pin connection chilla 21.06.2011 1.2 - created filter specification chilla 11.01.2012 - added terminating impedance - added typical values - changed triple transit delay - added filter characteristic - added test circuit - changed packing 1.3 - changed input power level chilla 27.03.2012 2.0 - added time gating window chilla 02.11.2012 - removed triple transit level and triple transit delay
|
